Advantages
- Modern, intelligent, microprocessor-controlled equipment
- Fully automatic operation
- Self fault indication for safety
- It has two chemical cell sensors
- Equipment according to EN 50545-1 standards
- Reasonable price
- National service background,
- 3-year warranty in case of operation according to the manual
Certificates
CE conformity
EN 50291,
EN 50402:2017,
EN 50104:2020,
EN 50271:2018,
EN 50402:2017,
EN 50054:2000,
EN 50057:2000,
System design
Sensing data
Detectable gas: CO
Measuring range: CO: 0-300 ppm
Calibration gas: COProposed signal levels on a time basis according to the standard
Wiring
Placement
The sensor must be placed 150-180 cm from ground level on a side wall or on a vertical surface at inhalation height. One sensor can cover an area of around 25-50 m2, but the design of the room and the areas where the gas can stop must be taken into account.
Cabling
Depending on the distance between the SENS-EX TG/AE-CO-AG sensor and the center, use a 4-core, 0.75-1.5 mm2, twisted-core cable with a shielded circular cross-section, max. resistance 25 Ohm/1000 m. Use the principle of wiring strung between the center and the detector, connect all the sensors in the system in series with a cable.
| Technical specification | |
| Supply voltage | 9-32 VDC |
| Power consumption | 15 mA |
| Sensor output signal | SENS-EX-V |
| Ambient temperature | -20°C to +50°C |
| Environmental pressure | 900-1100 mBar |
| Ambient humidity | 15 – 90 rH% |
| Protection (IEC 529) | IP20 |
| Size, weight | d=990 mm, h=480 mm; 150 gr. |
| Signal processing | Microprocessor |
| Cable connection (cable entry) | Terminal cell |
| Built-in sensor type | Chemical cell |
| Expected lifetime of the sensor | is 3-5 years |
| Method of sampling | Diffusion |
| Setup time | <30 sec |
| Flow rate | max 5 m/s |
Accessories/Order Information
TG/AI-CO-AG
Complete transmitter
